Your water heater is one of the most used and more expensive appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving at your home heating as well as costs.

Regular flushing of the water heater is among the single most important step you get to prolong its service life and to save energy. Over a period of time, sediments build up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. In part destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most involving the country, the common water heater lasts 3-5 years. Regularly flushing your water heater can double lifestyle of your hot water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is critical in today’s weather. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a nights.

To drain your water heater, on the internet should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is definitely an electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located on the water inlet line going into your water heater. After backing up connect a garden hose to the drain valve located towards the end of the hot water heater. Open the drain and allow it to move until all on the water has emptied from the heater. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until the water flows out perfectly. This will allow air to vent from the heater and the hot water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas possess hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and products to work for you.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2